-
Cc5a60c0 6672 497b 8a2a 74257e769730

invention

The Reading Arm #InventForGood

by TechTownStudents

Published on March 8, 2016

We completed this project using the new littleBits STEAM Student Set in the #InventForGood challenge.  The reading arm helps with homework.  Imagine sitting at your homework desk with papers everywhere and you are trying to look at all of them at once.  If you hold more than one document you lose use of your hands for writing.   The user clips a paper or note to the reading arm and can control the angle of the arm using a slide dimmer.  It can also be used by people with disability and motor issues.   The project is easy to assemble using household items and littleBits.  You can also embrace your artistic side and decorate the box and arm. 

Duration: 1 hour

How To Make It

STEP 1 : Assemble your supplies and put the bits together.

C28294fe f327 4e11 a32b 90a9c99aa0ad

All of the bits you need

Gather up the listed supplies. Attach your power bit to a wire. Your wire should attach to a slide dimmer. The side dimmer should attach to a servo motor. Make sure there is no arm currently attached to the servo and that it is set to "turn" mode.

STEP 2 : Cut a hole in the box

0581cb4f 8640 4681 8cea bae61334fe7e

Prepared box

You will need a hole in the top of the cardboard box for your servo to poke out of and control the arm. We used scissors to cut the hole but other cutting tools will do the job just as well.

STEP 3 : Mount the servo motor

Feed your servo motor through the hole in the box. We attached ours to a servo mount to make it easier to tape down. Use scotch tape to attach your servo motor to the top of the box. It is important to do this step before attaching the hub and arm or it will be more difficult to feed the servo through the hole.

STEP 4 : Ready and assemble the arm and hub

Eafa9c44 18f0 4d8f a8a4 f575e873ad12

Taped arm

C82a4890 34c6 481b acc6 208b833947b7

Mounted arm and hub

Tape two mechanical arms together end-to-end. We used duct tape with a 1 inch overlap between the two pieces to ensure stability. Screw the arm onto the servo hub and attach the servo hub onto the servo motor.

STEP 5 : Attach a document

70bc575d 7f2c 4b32 9e2d eb580e6963dc

Finished product

Once you have your arm set up at an angle you are happy with, attach a document to it by using two butterfly clips. Clamp the edge of the document down to the arm using the clips. You are now finished!

Related Projects

Inventions & Electronics

Invent and create your own amazing electronic hardware. Using American imported littleBits educational equipment, students will m...

Racer Car

Just a basic car that does not move and lights up on three sides.

#ChainReaction Bell

Here Jordi and Lucía. We've made a very special bell for the door. When you push the bell button, something magical begins ...