Pinkmodule

invention

littleBits in Space....nearly

by chrishillcox

Published on March 23, 2016


Wassup guys! We made this device to record air temperature using the littleBits space kit as our high altitude balloon floated up into the stratosphere. Our littleBits survived the big chil

Wassup guys! We made this device to record air temperature using the littleBits space kit as our high altitude balloon floated up into the stratosphere. Our littleBits survived the big chill!

Duration: 1 day if you are lucky

Credits: Aidan Hillcox and www.nearspacephotography.co.uk

How To Make It

STEP 1 : Make the temperature sensor

F1146483 af29 4af2 8722 4572df2e5d06

Circuit in box and insulation

The circuit cannot be simpler. We used the power unit with an Energiser lithium battery. Cold eats into the life of a battery so we used lithium batteries as they are the best to cope with this. The power unit is attached to the thermometer and number unit to display the temperature. We set this to Fahrenheit to give a greater range of temperatures displayed.

STEP 2 : Insulate the sensor from the cold.

The thick cardboard of the littleBits Space kit provides great insulation from the cold of near space, as does scrap packaging styrofoam. Hollow out the styrofoam to mount the circuit. Get as much of the battery in the Styrofoam by putting it lengthways through the Styrofoam. We put bubble wrap either end of the thermometer to limit the cold air getting into the rest of the box.

STEP 3 : Record the temperature.

45e09c10 4324 4d42 a51c fd8da82ac45d

video image of numbers display with time stamp.

This is done with a small light weight video camera. The type we used was Catcam but there are others available. Turn it on before the balloon is launched and record the time it is turned on.

STEP 4 : Check the temperature recordings and record thermometer height

8201f88e ec3d 4d52 ad32 c251087df05a

Zlog 7 GPs data logger in box

Use another video camera to record the view of the Earth. This allows you to find the time after launch in which the balloon bursts and the payload lands. You also need to record the time you turn this camera on. You can then correlate it with the video from the thermometer and find the temperature at burst point. We used a Zlog 7 GPS data logger to track the altitude of the balloon. The data is time stamped so you can correlate the altitude and temperature using time. It also had an external temperature sensor so we could check the accuracy of the littleBits Space thermometer.

STEP 5 : 5,4,3,2,1, Launch

7bd6b9fd 8f2f 447d bfc9 4b5dae6a1b21

Up, up, and away with the littleBits thermometer

High altitude balloon launches need FAA permission. In the UK it is the CAA. After you get permission then wait for a nice day in your launch window. The Little Bits box needs to be attached to a suitable parachute and balloon to take it into the Stratosphere. We filled the balloon with helium to lift the balloon but, with some care, you can use hydrogen too. We forecast the balloon trajectory and launched it on a day when the balloon drifted over open countryside. The littleBits was recovered using a SPOT GPS tracker and GSM locator but you can use radio tracking devices as well.

Related Projects

Swimming dolphin

we made a swimming dolphin that leaps through the water using  the DC motor, the slide dimmer (to control speed) and the powe...

The Nightmare Box #HackHalloween

The Nightmare Box#HackHalloween Take a rustic old box and fill it with the sequencer bit, and five Bright LEDs, and turn...

The Lazy Can Top Opener

When properly set up, this contraption can open a can only by flipping the power switch, saving you about 3 seconds.It can open no...